Databank

Workreport 2016-61

Back

Name:

Monitoring Hydraulic Conductivity with HTU in Drillholes OL-KR31 and -KR32 during the Year 2015

Writer:

Hurmerinta, E.

Language:

English

Page count:

816

Summary:

In July 2004 Posiva began to construct an underground rock characterization facility, ONKALO, at Olkiluoto. The construction of ONKALO and the subsequent construction of the repository of high-level spent nuclear fuel will affect the surrounding rock mass, the groundwater flow system and the environment in general. In December 2003 a programme to monitor these effects during the construction and operation of ONKALO was presented (Posiva 2003). Updated monitoring program was introduced in 2012 (Posiva 2012). The updated program will be used for the period before repository operation. The programme consists of different types of monitoring by different disciplines. HTU (Hydraulic Testing Unit) measurements are a part of the hydrogeological monitoring programme that includes measurements of hydraulic conductivity with HTU in drillholes near to ONKALO.

Measurements performed before and in the early stages of the excavation of ONKALO provide a baseline to which later results can be compared. The HTU monitoring measurement program was first completed in 2005 and then repeated in 2006 and in 2007 in drillholes OL-KR8, OL-KR28 and OL-KR31. Of these, OL-KR31 including its extension, was measured in 2008 and OL-KR32 was added to the program as a new hole. These same holes were measured yearly until 2012. After year 2012 the monitoring programme was intended to continue every other year, but measurements from 2014 were postponed to the year 2015 when drillholes OL-KR31 and OL-KR32 were measured.

Double-packer cons­tant-head method was used throughout with 2 m packer separation and a nominal 200 kPa overpressure. Injection stage lasted nor­mally 20 min­u­tes and fall-off stage 10 minutes. The tests were shortened if there were clear indications that the hydraulic conductivity was below the measuring range of the system. The pressure in the test section was let to stabilize 5 minutes before injection, occasionally longer or shorter. Also, the injection and fall-off were extended when necessary to obtain a stationary state or suited the schedule. Two tran­sient (Horner and 1/Q) in­terpreta­tions and one stationary-state (Moye) in­terpreta­tion were made in-situ immediately after the test. In 2015 a total of 238 tests were accomplished covering altogether 475.4 m of drillhole in these two holes.

The Hydraulic Testing Unit (HTU-system) is owned by Posiva Oy and it was operated by Pöyry Finland Oy.

Keywords:

HTU, hydraulic conductivity, constant head test, hydraulic injection test.

File(s):

Monitoring Hydraulic Conductivity with HTU in Drillholes OL-KR31 and -KR32 during the Year 2015 (pdf) (7.4 MB)


Back


Share article: